NetCommWireless
Connecting via Ethernet
Before connecting the Ethernet cable (not supplied) you must first connect the Ferrite Core and
cable gland.
Connecting the Cable Gland
1.
Take a cable gland, unscrew the thread lock sealing nut, and remove the inner seal as shown below.
2.
Thread the Ethernet cable through the thread lock sealing nut. Open the claw and the seal to place the
cable through it and then pass cable through the body of the cable gland. Align the gland segments in
the orientation as shown below. Plug the seal through the body and tighten the nut.
3.
Tighten the cable gland to ensure the seal is adequate. Use a shifter or spanner to ensure IP67 rating.
8