Table of Contents
Advertisement
MAJOR OPERATING CONTROLS AND THEIR FUNCTIONS
POWER
ON
SWITCH
PROTECTER
OFF
8
7
IN
OUT
8
7
1. Power ON/OFF Switch (POWER)
This switch turns the power of this unit on or off. The
POWER indicator lights when the power of this unit
is on.
Switch Protector (Standard Accessory)
To prevent that the power of this unit is turned off acci-
dentally, install the supplied switch protector as shown
below.
2. Alarm LED (ALARM)
This LED flashes to indicate an alarm condition
exists.
It changes to steady light when the alarm is reset
automatically.
To turn the LED off, press the ALARM RESET/QUAD
SHIFT/MULTISCREEN button.
3. Alarm Reset/Quad Shift/Multiscreen Button
(ALARM RESET/QUAD SHIFT/MULTISCREEN)
This button has different functions in different
modes, as described below.
• ALARM RESET button
When an alarm signal is received, this button works
as the ALARM RESET button.
Pressing this button in an alarm situation cancels
the alarm mode with the following results:
1. The alarm LED stops flashing.
2. The alarm output is stopped.
3. The alarm buzzer stops beeping.
4. The video loss caution message on the monitor
screen disappears.
ALARM RESET
ALARM
MULTISCREEN
1
2
3
QUAD SHIFT
CURSOR
6
5
4
3
2
1
VIDEO
OUT
VCR
OUT
6
5
4
3
2
1
VIDEO
VIDEO SELECT
MENU
MODE
4
5
6
7
8
SELECT
ESC
GENLOCK
IN
PLAY IN
ALARM/REMOTE
GENLOCK
OUT
(VS1Vp-p)
• MULTISCREEN button
Pressing this button changes the camera picture to
quad picture (QUAD A or QUAD B) or to 3x3 pic-
ture. To display the multiscreen, the setting of the
VCR OUT menu is required. See page 8 for details.
• QUAD SHIFT button
When monitoring a quad picture, pressing this but-
ton shifts to another quad picture.
4. VIDEO SELECT (1....8)/CURSOR
SELECT (–, +) Buttons
These buttons select the video signal to monitor it in
full-size single picture or move the cursor on the
setup menus.
• VIDEO SELECT (1....8) buttons
When the setup menu is not displayed, these but-
tons work as VIDEO SELECT buttons.
Pressing one of these buttons selects a channel to
be displayed in single picture mode.
The indicator in the button lights to indicate the
number of the selected camera.
(C C ,D D ,A A
• CURSOR
When the setup menu is displayed, these buttons
work as CURSOR
tons.
Pressing these buttons moves the cursor or selects
a mode or a parameter.
Except for buttons No. 7 and 8, the function of these
buttons changes according to the selected mode.
The functions of each button are as follows:
-3-
MODE SELECT
SET/RESET
SEQ
PLAY
EL-ZOOM
STILL
Quad System WJ-MS
RS-232C
SIGNAL
GND
(C C ,D D ,A A
B B
,
)/SELECT (–, +) buttons
(C C ,D D ,A A
B B
,
)/SELECT (–, +) but-
B B
,
)/
Advertisement
Table of Contents
