Table of Contents
Advertisement
OPERATION
With this unit, different multi picture never can be sent to
the VCR OUT connector (VCR) and the VIDEO OUT
connector (Video Monitor) simultaneously. See block
diagram of this unit on page 26.
You can monitor camera picture and playback picture in
various ways by selecting different mode (SEQ, PLAY,
EL-ZOOM, and STILL). See page 4 for details about
each mode.
To Set the Mode
1. Select the desired mode by pressing the MODE but-
ton. (Indicator lights to show selected mode.)
2. After selecting the desired mode, press the SET but-
ton.
The selected mode indicator goes off and the next
indicator lights.
To Reset the Mode
1. Select the mode to be reset by pressing the MODE
button. (Indicator lights to show selected mode.)
2. After selecting the mode to be reset, press the
RESET button.
The selected mode indicator goes off and the next
indicator lights.
To Check the Current Mode
Note: The mode indicators do not indicate an activated
mode. They are used only to select the mode. You
can check the current mode by setting the parame-
ters of PLAY TITLE, STILL-SEL TITLE ( on SYSTEM
SETUP menu), and ZOOM TITLE (on ZOOM SETUP
menu) to ON.
You can check which mode is currently selected on the
monitor screen:
SEQ: When the picture (full size single or quad) is dis-
played sequentially, the current mode is SEQ. See
page 17 for details.
PLAY: When the word "PLAY" is displayed, the current
mode is PLAY. To display the word "PLAY", setting
of the PLAY TITLE parameter is required. See page
10 for details.
EL-ZOOM: When the word "ZOOM" is displayed, the
current mode is EL-ZOOM. To display the word
"ZOOM", setting of the ZOOM TITLE parameter is
required. See page 10 for details.
STILL: When the word "STILL?" is displayed, the cur-
rent mode is STILL. To display the word "STILL?",
setting of the STILL-SEL parameter is required. See
page 11 for details.
Monitoring the Camera Picture
A. Full Size Single Picture
1. Confirm that neither SEQ, PLAY, EL-ZOOM, nor
STILL mode is the current mode. If the current mode
is any one of the above, reset the mode.
2. Press the desired VIDEO SELECT button. The
selected camera picture appears on the monitor
screen.
-15-
ENTRANCE
Camera Picture
Advertisement
Table of Contents
