Installation Instructions - Fisher & Paykel WashSmart Installation Instructions And User Manual

Unpacking
To ensure the best performance from your new
washer please follow the instructions below.
Removing the packaging
Remove the outer packaging.
1
Tilt the machine backwards and walk it off the bottom
2
packer one foot at a time (ensure lid is still taped down).
Remove the bottom packer from under the machine by
3
tilting the machine backwards and pulling the packer
out the front.
Remove the tape, lift the lid and remove the bowl
4
packer from the bowl.
Remove the hoses and accessories.
5
Keep the bottom packer and bowl packer in case they are required for future transit.
6
Important!
Please ensure that the bottom packer has been removed BEFORE OPERATING your machine.
Location
Your washer must be installed on a level surface and not on any textured floor coverings
(eg carpet, rugs) to ensure that the opening at the bottom of the machine is not obstructed.
In your clothes washer you will find:
1 hose guide.
2 inlet hoses.
4 rubber foot inserts.
Drain hose
Carefully pull the drain hose out from the back of
1
the machine by pulling the exposed part of the
hose downward and outward.
To guide the drain hose over the tub or standpipe
2
the hose guide MUST be fitted to the drain hose.
Important!
To prevent siphoning the drain hose should not
extend more than 20 mm from the end of the
guide. The height of the standpipe or tub should
be between 850 – 2400 mm. The drain hose can be
trimmed to length.
Place the drain hose in the tub or standpipe.
3
Do not fit the hose to a drain spigot. Drainage must
not be airtight in order to prevent siphoning.

Installation instructions

Fig.1 Tilt washer backwards to remove packer
Pull hose
through
guide
Flex hose
guide apart
Fig.2 Fitting the drain hose guide
3
(20 mm)
maximum