Removing The Inverter Board - Clevo M720T Service Manual

Disassembly

Removing the Inverter Board

Figure 8
Inverter Board
1. Turn off the computer, and remove the battery
Removal
2. Remove any rubber covers, screws
carefully unsnap the LCD front panel module
a. Remove the 6 screws
3. Discharge the remaining system power (see
and unsnap the LCD
4. Remove screws
front panel module from
5. Disconnect cables
the back.
b. Remove the screw and
case assembly.
discharge the remaining
power from the inverter
a.
board and lift the board
up slightly.
c. Disconnect the cables
from the inverter.
d. Remove the inverter.
7. LCD Front Panel
12. Inverter Board
• 8 Screws
2 - 12 Removing the Inverter Board
1
- (Figure 8b) from the inverter, and carefully lift the inverter board up slightly.
8 9
& (Figure 8c) from the inverter, then remove the inverter
10 11
3
2 4
1
7
Inverter Power Warning
In order to prevent a short circuit when removing
the inverter it is necessary to discharge any re-
maining system power. To do so, press the com-
puter's power button for a few seconds before
disconnecting the inverter cable.
(page 2 - 5).
- (Figure 8a), then run your finger around the middle of the frame to
6
from the back.
7
"Inverter Power Warning"
b.
5
8
c.
6
10
d.
below).
(Figure 8d) from the top
12
9
11
12