Removing The Inverter Board - Clevo M720T Service Manual

Removing the Inverter Board

1. Turn off the computer, and remove the battery
2. Remove any rubber covers, screws
carefully unsnap the LCD front panel module
3. Discharge the remaining system power (see
4. Remove screws - (Figure
8 9
5. Disconnect cables & (Figure
10 11
case assembly.
a.
3
2
1
7
Inverter Power Warning
In order to prevent a short circuit when removing
the inverter it is necessary to discharge any re-
maining system power. To do so, press the com-
puter's power button for a few seconds before
disconnecting the inverter cable.
(page 2 - 5).
- (Figure 7a), then run your finger around the middle of the frame to
1
6
from the back.
7
"Inverter Power Warning"
7b) from the inverter, and carefully lift the inverter board up slightly.
7c) from the inverter, then remove the inverter
b.
4 5
c.
6
d.
below).
(Figure 7d) from the top
12
8 9
10
12
Removing the Inverter Board 2 - 11
Disassembly
Figure 7
Inverter Board
Removal
a. Remove the 6 screws
and unsnap the LCD
front panel module from
the back.
b. Remove the screw and
discharge the remaining
power from the inverter
board and lift the board
up slightly.
c. Disconnect the cables
from the inverter.
d. Remove the inverter.
11
7. LCD Front Panel
12. Inverter Board
• 8 Screws