Setup; Ac Power; Fuse Replacement - Chauvet Intimidator Barrel LED 300 User Manual

3. S
ETUP

AC Power

Fuse
Replacement
Intimidator™ Barrel LED 300 User Manual (Rev. 5)
The Intimidator™ Barrel LED 300 has a dual voltage power supply and it can work with
an input voltage of either 120 V, 60 Hz or 230 V, 50 Hz, depending on the position of the
voltage selection switch.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
Follow the instructions below to change the fuse, if necessary.
Disconnect the product from the power outlet before replacing the fuse.
1. Disconnect this product from the power outlet.
2. Using a Phillips #2 head screwdriver, unscrew the fuse holder cap from the housing.
3. Remove the blown fuse and replace with a good fuse of the same type and rating.
4. Screw the fuse holder cap back in place and reconnect power
The product does not ship with a spare fuse; however, the safety cap has room
for a spare.
Page 7 of 18