Oven Lamp Replacement - Zanussi ZCM 5262 Instruction Book

How to proceed?
•
Unscrew and remove the protective cover at
the back of the appliance;
•
Connect the power cord to the terminal of
the cooker according to the table no.1;
•
Fix by means of cable clamp;
•
Make sure that the connection to the
terminal is matching the network power;
•
Remount and screw the protective cover at
the back of the appliance.
Connection type
Cable connection to the
terminal plate
Network power
Voltage of heating
elements
Fusible capacity
Cable section
Before replacing the lamp take care that
all control knobs be on "off" position « 0 ».
Disconnect the appliance; watch that the
oven be cool.
This lamp of 15 W, convection E 14 (230/240V)
is a special lamp for "higher" temperature,
up to 300˚C. It is supplied on order, by your After
Sales Service.
The lamp is fixed in front of the oven and is
accessible from inside.
For reaching the lamp:
1. Unscrew the glass lamp protection (fig. 25);
2. Unscrew the lamp;
3. Replace the lamp;
4. Remount the lamp protection
During use the appliance becomes hot.
Care should be taken to avoid touching
heating elements inside the oven.
Table no.1
Single phase
1 2 3 4 5
1 2 3 4
L1
L1
N PE
230 V
230 V
20 A
3 x 2,5 mm² 4 x 1,5 mm²

OVEN LAMP REPLACEMENT

Tri-phase Y 3 ph. +
Tri-phase
neutral
5 1 2
L1 L2
PE
L2 L3
230 V 230 V / 400 V
230 V
16 A
5 x 1 mm²
fig. 25
Tri-phase Y 2 ph. +
neutral
4 5
1 2 3
3
N PE
L3
L1 L2
230 V / 400 V
230 V 230 V
10 A
4 x 1,5 mm²
4 5
PE
N
16 A
19