Maintenance And Cleaning - Zanussi ZCM 5262 Instruction Book

Before cleaning, check that the knobs
are on "off" position, that the appliance has
cooled completely
disconnected.
Never use abrasive powder or wire
sponge for cleaning the appliance.
Burners
Clean the covers with warm water and mild
detergent, remove all crust.
Never use vinegar.
The flame splitters have to be kept clean for
ensuring good ignition.
Before igniting make sure the flame splitter and
the caps are properly replaced.
The assembly has to be perfectly dry.
Control panel, knobs, enameled pan support,
cover, front and side panels
For cleaning them use a wet sponge with a soft
detergent, rinse and dry.
Hob
After every use wipe it with a sponge soaked in
warm detergent water, avoiding leakage through
the wholes of the hob. Rinse and dry with a soft
cloth.
In case of overflowing, wet and leave it
dissolving but do not scratch and avoid use of
abrasive or caustic products that could damage
the enamel.
Wipe immediately the stains of vinegar, lemon,
generally the acid substances.
Hot plate
Use a wet sponge and detergent, rinse and dry.
If necessary heat beforehand the plate for
burning the dirt.
The plates must be maintained dry.
From time to time you can wipe with an
absorbant paper lightly oiled.
Cleaning of the accessories.
Clean them with warm water and detergent,
rinse well and dry.
Oven
Enamelled parts: Same cleaning as other
enamelled parts.
Oven door cleaning
For a complete cleaning of the oven door it is
advisable to dismantle as follows:
-
open the door completely (fig. 17)
- turn the two blocking parts on the hinges
arms 60º.

MAINTENANCE AND CLEANING

and that it is
fig. 17
- close partially the door, to a 30º angle (fig. 18).
- lift the door and pull it out.
fig. 18
The internal oven door glass can be removed for
cleaning. For this purpose draw out the 2 fixing
screws (fig. 19).
fig. 19
Important: The inner glass has to be always in
place when using the oven.
13