Table of Contents
Advertisement
The appliance ran be connected to the gas
supply, right or left side, by one print of
connection. The end of the distributing pipe is
threaded.
It is necessary to route the connecting hose
(flexible) at the back of the appliance as shown in
the diagram (see fig. 24). Ensure that the rubber
hose is not in contact with any part of the
hatched area shown in the diagram. The hose
has to be fixed in the support by means of the
clamp supplied. The hose should not have
narrow curves or throttlings. Check tightness with
soapy water.
Electrical connection
Important
Any electrical work required to install
this hob should be carried out by a qualified
electrician
or
competent
accordance with the current regulations.
THIS COOKER MUST BE EARTHED.
The manufacturer declines any liability
should
these
safety
observed.
Before
switching
electricity supply voltage is the same as that
indicated on the rating plate.
Note:
In case of a direct connection to the mains you
have to interpose an omnipolar switch a
minimum opening between contacts of 3 mm.
The switch should be sited within 2m of the hob
and be easily accessible upon completion of the
installation.
The yellow-green grounding cable has not to be
interrupted by the switch.
Ensure that the supply cord is not in contact with
any part of the hatched area shown in the
diagram (fig. 24).
NOTE: The earth wire should be about 2 cm
longer than the live and neutral wires.
To use cable type H05 RR-F with the section
indicated in the table no.1.
Before connecting check that:
•
fuse and household electric installation can
bear the charge of the appliance (see rating
plate);
18
person,
measures
not
on,
make
sure
fig. 24
in
be
the
connection of
flexible hose
clamp
Advertisement
Table of Contents
