Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Zanussi ZCM 5262
Summary of Contents for Zanussi ZCM 5262
- Page 1 INSTRUCTION BOOK ZANUSSI ELECTRIC GAS COOKER Model: ZCM 5262...
-
Page 2: Table Of Contents
CONTENTS Instructions for the user Instructions for the installer Technical Features After Sales Service Warnings Advice for safety Description of the appliance Installation Use of the appliance Oven lamp replacement Advice for use Change of gas Maintenance and clening What to do if the appliance does not work Guarantee conditions How to read the instruction book ? The symbols below will guide you when reading... -
Page 3: Technical Features
TECHNICAL FEATURES Free standing Class 1 Cover Enamelled Pan support Enamelled Front left Normal electric plate 1000 W Back left Rapid electric plate 1500 W Back right Auxiliary 1000 W Front right Rapid 2600 W Oven Electric Oven Over burner power 1700W Grill electric... -
Page 4: Warnings
WARNINGS It is very important that this instruction book • An intensive and prolonged use of the should be kept safety for future consultation. If it cooker could necessitate a supplementary should be sold or given to another person, please airing by opening the window, or a more ensure that the booklet goes together with it, so effective ventilation by increasing the... - Page 5 • Ensure that children do not handle the knobs of the appliance. • Before cleaning disconnect the appliance and allow to cool. • Never use the ignited burners without a pot • For reasons of good culinary results, hygiene and safety this appliance must always be kept clean, the fat sprinklers could give off unpleasant smells.
-
Page 6: Description Of The Appliance
DESCRIPTION OF THE APPLIANCE Control panel Model : ZCM 5262 OVEN ZANUSSI OVEN HOT PLATE HOT PLATE MAIN PILOTS THERMOSTAT IGNITION OVEN FRONT BACK BACK FRONT SWITCH KNOB LEFT LEFT RIGHT RIGHT HOT PLATE HOT PLATE BURNER BURNER CONTROL CONTROL... -
Page 7: Use Of The Appliance
USE OF THE APPLIANCE 1. Electric traditional oven Before the first use ensure that the room well ventilated: V.M.C. (Mechanic ventilation) opened window. How to proceed ? 1. Lift the lid 2. Remove the oven accessories 3. Detach adhesive labels, foil protection if there is 4. -
Page 8: Electric Grill
If you want more heat coming from the bottom or more heat coming from the top, turn the knob so as to place the pointer on the symbol (bottom heat) (top heat). Under these circumstances the temperature will never exceed about 215ºC in the bottom heat and in the top heat position too. - Page 9 Grilling Heat comes from the top of the oven. It is suitable for grilling meat (beef bacon, pork bacon …) that remains tender, for toast or to brown already cooked. When using the grill it has to be supervised, oven door opened protective screen in its place.
- Page 10 Turn-spit When using the turn-spit, the accessible parts of the appliance are hot and the appliance should not be left unsupervised. Take care that children do not play near it. While the turn-spit is operating leave the oven door half open and put the grill deflector “A” into place.
-
Page 11: Electric Hotplates
Ignition of the burners 1. Push the knob and turn it left to the “large flame” symbol. 2. At the same time, push the electronic ignition knob (fig. 11) for obtaining sparkles. Keep it pushed till turning up of the flame (1 spark / second). - Page 12 To spare the hot plate and for saving power, we advise you: 1. to use flat bottom pots, with the right diameter, never smaller. 2. avoid liquids over flowing when boiling. 3. never leave the plates on without a pot on them or with an empty pot on them.
-
Page 13: Advice For Use
Accessories delivered with the appliance Beside the accessories delivered with the appliance we advise you to use only heat proof pots (according to the instructions of the manufacturer). Your cooker is equipped with (fig. 16) : • a grate, pan support for putting the dishes on (roast, pastry moulds …) The dish has to be put in the middle of the grate to balance the weight. -
Page 14: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before cleaning, check that the knobs are on “off” position, that the appliance has cooled completely that disconnected. Never use abrasive powder or wire sponge for cleaning the appliance. Burners Clean the covers with warm water and mild detergent, remove all crust. -
Page 15: What To Do If The Appliance Does Not Work
WHAT TO DO IF THE APPLIANCE DOES NOT WORK If the appliance does not work properly, check the following points before asking for service; there could be simple problems that you could remedy by yourself; if not, contact your after sales service. Symptoms Solutions No burner ignites... -
Page 16: Guarantee Conditions
GUARANTEE CONDITIONS abnominal power variation, etc., or non- Guarantee stipulated in the contract 1 year starting from setting into function the observing of the installation and use conditions manufacturer will replace the damaged parts stipulated in the Instruction book, wrong except cases mentioned... -
Page 17: Instructions For The Installer
INSTRUCTIONS FOR THE INSTALLER Electric connection ADVICE FOR SAFETY • Before installation ensure that the local Check that: distribution conditions (gas nature • the power of the installation is enough; pressure) and the pre-setting of the appliance • the supplying lines are in good conditions; are consistent and the voltage and the •... - Page 18 An intensive and prolonged use of the cooker could necessitate a supplementary airing by opening the window, or a more effective ventilation by increasing the mechanical device power, if there is. Gas connection Your cooker is delivered adjusted for the kind of gas stated on the rating plate.
-
Page 19: Electrical Connection
The appliance ran be connected to the gas supply, right or left side, by one print of connection. The end of the distributing pipe is threaded. It is necessary to route the connecting hose (flexible) at the back of the appliance as shown in the diagram (see fig. -
Page 20: Oven Lamp Replacement
How to proceed? • Unscrew and remove the protective cover at the back of the appliance; • Connect the power cord to the terminal of the cooker according to the table no.1; • Fix by means of cable clamp; • Make sure that the connection to the terminal is matching the network power;... -
Page 21: Change Of Gas
CHANGE OF GAS Your cooker is foreseen to work with natural Stick the label delivered with the gas, propane or butane. It is not foreseen for appliance (spare nozzles, corresponding to butane or propane air. the type of gas used). For changing the gas type it is necessary to: •...