Table of Contents
Advertisement
Error message
Check Fax Mode
HANG UP THE PHONE
LINE PROBLEM
CHECK LINE
MEMORY FILE FULL
MEMORY FULL
REDIAL ALL FAILED
Cause
A fax error occurred while an
operation was being performed
in Copy mode or Scan mode.
The receiver of the connected
telephone is lifted.
❏
The telephone dialing
system or telephone wiring
system is not set correctly.
❏
The telephone cable is not
attached correctly.
The number of items registered in
the memory has exceeded the
maximum allowed.
❏
While sending a fax, the size
of the data for the scanned
image has exceeded the
capacity of the memory.
❏
While receiving a fax, the size
of the data for the scanned
image has exceeded the
capacity of the memory.
All redial attempts failed because
either the recipient's line is busy
or there was no answer.
Epson AcuLaser CX37DNF
Solution
Press the Fax key to check the error condition,
and take appropriate measures.
Replace the receiver of the connected
telephone on the hook.
❏
Check the telephone dialing system or
telephone wiring system and use the
appropriate configuration menu to make
the correct settings.
❏
Correctly connect the telephone cable.
If MEMORY RX MODE is set to ON, cancel memory
reception mode, and print received
documents stored in the memory.
❏
If MEMORY RX MODE is set to ON, cancel
memory reception mode, and print
received documents stored in the
memory.
❏
Send the fax manually.
Check the condition of the recipient's line, and
then try sending the fax again.
Facsimile User's Guide
Troubleshooting
76
Advertisement
Table of Contents
