Sending A Fax To Multiple Recipients (Group Dial) - Epson AcuLaser CX37DNF User Manual

5. Press the Start key.
The document is scanned, and then the fax is sent.
Note:
❏ To stop the transmission, press the Stop/Reset key. A message appears, requesting confirmation
to cancel the setting. Select YES, and then press the Select key. If this is done, all selected
recipients are cleared.
❏ If FAX TX in ADMIN. MANAGEMENT/PASSWORD SETTING/FULL FUNC. NO. has been
restricted, type in the number specified for FULL FUNC. NO. after pressing the Start key.

Sending a Fax to Multiple Recipients (Group Dial)

Multiple destinations can be selected with a group dial destination.
Note:
Multiple destinations must have been previously registered with a group dial destination. For details,
refer to "Registering a Group Dial Destination" on page 64.
1. Press the Addressbook key 3 times.
Note:
The Addressbook key can be used if the main screen or Can Use AddressBook is displayed.
2. Use the keypad to type in the group dial number (1-20), and then press the Select key.
Note:
❏ If a number was incorrectly entered, press the Back key, and then type in the correct number of
the group dial destination.
❏ If the entered group dial number is not registered with a fax number, the message NOT FAX NO.
appears. In addition, if the entered group dial number is not registered with a recipient, the
message NOT REGISTERED! appears. Enter a group dial number registered with a fax number.
3. When OK=Select appears, press the Select key again.
4. Press the u or d key to select FINISH, and then press the Select key.
Note:
To erase the selected destinations, press the Stop/Reset key.
Epson AcuLaser CX37DNF Facsimile User's Guide
Sending Faxes 34