Table of Contents
Advertisement
Electrical Installation
Interconnection wiring is required between the motor control, AC power
source, motor, host control and any operator interface stations. Use UL listed
closed loop connectors that are of an appropriate size for the wire gauge
being used. Connectors are to be installed using crimp tool specified by the
manufacturer of the connector. Only Class 1 wiring should be used.
System Grounding
Baldor controls are designed to be powered from standard three phase lines
that are electrically symmetrical with respect to ground. System grounding is
an important step in the overall installation to prevent problems.
Input Current Requirements
Table 3-2 Input Current Requirements for Stock Products
115VAC − 1f
Catalog
Input
Numbers
Amps
ID15P1F33−ER
ID15P1F50−ER
ID15P1F75−ER
ID15P101−ER
Cover Removal
The cover is made of plastic and could be damaged during removal if handled
roughly. Refer to Figure 3-1. Insert a screw driver or small blade tool and pry
the cover outward as shown to release the side.
When both sides are released, remove the cover.
Use small screw driver or
suitable tool to pry cover
slightly outward to release
cover from its catch.
MN715P
230VAC − 3f
Catalog
Numbers
3.5
ID15P201−ER
5.0
ID15P201F5−ER
7.5
ID15P202−ER
10.0
ID15P203−ER
ID15P205−ER
Figure 3-1 Cover Removal
460VAC − 3f
Input
Catalog
Amps
Numbers
4.5
ID15P401−ER
7.0
ID15P401F5−ER
8.0
ID15P402−ER
11.0
ID15P403−ER
15.0
ID15P405−ER
ID15P407−ER
ID15P410V−ER
Use small screw driver or
suitable tool to pry cover
slightly outward to release
cover from its catch.
Receiving and Installation 3-2
Input
Amps
2.5
3.5
4.0
5.5
9.0
10.0
13.0
Advertisement
Table of Contents
