Erasing The Locally Defined Sip Settings; Accessing Status Information - Cisco SIP IP Phone Administrator's Manual

Accessing Status Information

Erasing the Locally Defined SIP Settings

When you erase the locally defined SIP settings, the values are reset to the defaults.
If your system has been set up to have the phones retrieve their SIP parameters via a TFTP server, you
Note
must edit the configuration file in which a parameter is defined to delete the parameter. When deleting
a parameter, remove the variable in the file or change its value to a null value "" "" or
"UNPROVISIONED". If both the variable and its value are removed, the phone uses the setting for that
variable that it has stored in Flash memory.
If the
Note
configuration can be erased. Use the erase_protflash command so that the phone can retrieve its config
files.
Before You Begin
Unlock configuration mode as described in the
Press the settings key. The Settings menu appears.
Step 1
Step 2 Highlight SIP Configuration.
Step 3 Press the Select soft key. The SIP Configuration settings are displayed.
Step 4 Highlight the parameter for which you want to erase the setting.
Step 5 Press the Edit soft key.
Step 6 Press the << soft key to delete the current value.
Step 7 Press the Validate soft key to save your change and exit the Edit panel.
If modifying a line parameter, press the Back soft key to exit the Line Configuration panel.
Step 8
Step 9 Press the Save soft key. The phone programs the new information into Flash memory and resets.
Accessing Status Information
There are several types of status information that you can access via the settings key. The information
that you can obtain via the settings key can aid in system management.
To access status information, select settings and then select Status from the Settings menu. From the
Status menu, the following three options are available:
•
•
•
In addition to the status messages available via the Setting Status menu, you can also obtain status
messages for a current call.
Cisco SIP IP Phone Administrator Guide
3-42
telnet_level parameter is set to allow privileged commands to be executed, the entire SIP
Status Messages—Displays diagnostic messages.
Network Status—Displays performance messages.
Firmware Version—Displays information about the current firmware version on the phone.
Chapter 3
"Unlocking Configuration Mode" section on page
Managing Cisco SIP IP Phones
3-2.