Cisco SIP IP Phone Administrator's Manual page 85

Chapter 3 Managing Cisco SIP IP Phones
Table 3-7 CLI Commands (continued)
Command
SIP Phone> show {arp | debug | strpool | memorymap |
dump | malloctable | stacks | status | abort_vector
| flash | dspstate | rtp | tcp | lsm | fsm | fsmdef
| fsmcnf | fsmxfr | fim | gsm | register | network |
config | personaldir | dialplan | timers}
Purpose
Shows information about the SIP IP phone. The following
keywords are used:
arp: Displays contents of the ARP cache.
•
debug: Shows which debug modes are activated.
•
strpool: Shows the string library pool of strings. This
•
command can only be used if the
is set to allow privileged commands to be executed.
• memorymap: Shows memory mapping table, including
free, used, and wasted blocks.
• dump: Displays a dump of the memory contents. This
command can only be used if the
is set to allow privileged commands to be executed.
• malloctable: Shows the memory allocation table.
• stacks: Shows tasks and buffer lists.
• status: Shows the current phone status, including errors.
• abort_vector: Shows the address of the last recorded
abort vector.
• flash: Shows flash memory information.
• dspstate: Shows the DSP status, including whether the
DSP is ready, the audio mode, if keepalive pending is
turned on, and the ringer state.
• rtp: Shows packet statistics for the RTP streams.
tcp: Shows the status of TCP ports, including the state
•
(listen or closed) and the port number.
lsm: Shows the current status of the Line Manager
•
control blocks.
fsm: Shows the current status of the Feature State
•
function control blocks.
fsmdef: Shows the current status of the default Feature
•
State Manager data control blocks.
fsmcnf: Shows the current status of the Conference
•
Feature State Manager call control blocks.
fsmxfr: Shows the current status of the Transfer Feature
•
State Manager transfer control blocks.
• fim: Shows the current status of the Feature Interaction
Manager control blocks (interface control blocks and
state control blocks).
• gsm: Turns on debugging for vcm, lsm, fim, fsm, and
gsm.
Cisco SIP IP Phone Administrator Guide
Using the Command-Line Interface
telnet_level parameter
telnet_level parameter
3-33