Furuno FSV-84 Installation Manual page 56

CIF BAUD RATE: Set the transmission rate for the CIF port. If the CS-120A is connected,
choose "2400 bps". (2400 bps, 4800 bps, 9600 bps, 19200 bps)
AUX BAUD RATE: Set the transmission rate for the AUX port. (2400 bps, 4800 bps, 9600
bps, 19200 bps)
SENSOR BAUD RATE: Set baud rate of satellite compass, connected to the transceiver
unit. (4800 bps, 9600 bps, 19200 bps, 38400 bps.) For SC-50/SC-110, select 38400 bps.
Note: Set NMEA output for SC-50/SC-110 as follows:
- Output format: IEC ed1
- Sentence: ATT, HVE (turn off all other sentences except those two)
- Baud rate: 38400 bps
- Interval: 25 ms
(Any talker)
EXT KP INPUT: Set the input logic of KP from external equipment. (DISABLE, ↑, ↓)
DISABLE: Disable external KP.
↑: Synchronize with leading edge of input pulse.
↓: Synchronize with trailing edge of input pulse
Note: To transmit with external KP, set the TX INTERNAL to "0" in the H-SCAN SETTING
menu.
EXT KP OUTPUT: Choose the KP output logic, POSITIVE or NEGATIVE. (POSITIVE,
NEGATIVE)
3.4.2 EXT DATA SETTING menu
DATE & TIME: Choose the input format for data and time data. (NONE, CIF, NMEA)
HEADING: Choose the input format for heading data. (NONE, AD10S, CIF, NMEA)
LOG PULSE: Set the log pulse rate for the log signal. (200 p/NM, 400 p/NM)
3-8
MENU
EXT DATA SETTING
DATE&TIME : CIF
HEADING : AD10S
LOG PULSE : 200p/NM
SPEED&COURSE : NMEA
SPEED SENSOR : GPS/DR
LAT/LON : NMEA
POSITIONING SENSOR : AUTO SEL.
WATER DEPTH : NMEA
WATER TEMP. : NMEA
WATER CURRENT : CIF
WIND : CIF
NET DEPTH : PULSE
EXT DATA SETTING menu
QUIT
QUIT