Table of Contents
Advertisement
Positioning guide pins
Guide pins of the connector identify the mating receptacle. They are;
• Guide pin A (Large): 4
• Guide pin B (Small): 1
Use the tool (Type: 10-910-0179-0) shown below to position guide pins.
Guide Pin
Guide Pin A (Large)
Guide Pin B (Small)
Assembling BNC connector (CN-A304 to CN-A 308)
1. Remove vinyl sheath of the cable by 7.5 mm.
2. Pass the cable through the nut, washer, gasket and
clamp.
3. Unravel the shield and fold it back onto the clamp.
4. Remove the insulator, leaving 3 mm.
5. Trim the shield as shown in the drawing. Solder the
center chip to the conductor of the cable.
6. Pass the cable through the housing and tighten the
nut.
Connector
CN-A303
4
1
Tool
Guide pin insertion tool (notch in head)
Housing Clamp Washer Nut
Center Pin Gasket
7.5
Shield
3
2-5
Hide quick links:
Advertisement
Table of Contents
