Furuno FSV-84 Installation Manual page 38

Positioning guide pins
Guide pins of the connector identify the mating receptacle. They are;
• Guide pin A (Large): 1
• Guide pin B (Small): 1
Use the tool (Type: 10-910-0179-0) shown below to position guide pins.
Guide Pin
Guide Pin A (Large)
Guide Pin B (Small)
2.4.2 Power cable
Attach the NCS-253-P connector to the power cable (DPYCY-1.5 or equivalent) and connect
to the CN-A110 on the rear of the processor unit.
Slip on heat-shrink tubing
or elastic tubing and heat.
#2
#3
#1
Solder lead wire to armor and
Solder lead wire to armor and
connect it to #1 pin of connector. connect it to #1 pin of connector.
2.4.3 Cable from monitor unit
Connect the cable 10S2074 (10 m) or 10S2075 (30 m) from the monitor unit to the
connectors in the processor unit as shown below.
38P connector: CN-A103 (For the optional sub-monitor display, CN-A108)
D-sub 25 pin: CN-A102 (For the optional sub-monitor display, CN-A107)
D-sub 15 pin: CN-A104 (For the optional sub-monitor display, CN-A109)
2.4.4 Cable from control unit
For blackbox configuration, attach the cable (10S2076) from the control unit (FSV-8401) to
CN-A103 on CONE Board (10P6905) in the processor unit, passing it through the cable
clamp in the processor unit.
2-10
Connector
CN-A101
4
1
Armor
Armor
Assembling connector NCS-253-P
Tool
Guide pin insertion tool (notch in head)
Vinyl sheath Vinyl sheath
Taping
Taping
Use cable DPYCY-1.5
(Japan standard cable)
or equivalent cable.
Cable DPYCY-1.5
Vinyl
sheath
Conductor
2
S = 1.5 mm
φ
= 1.56 mm
Armor