Table of Contents
Advertisement
Passing the cable through the bottom of the control unit (for permanent mounting)
For permanent mounting methods (2) and (3), the control cable can be passed through the
bottom of the control unit as follows:
1. Unfasten eight screws (M4) to
remove the cover from the bottom
of the control unit.
2. Unscrew two screws (M4×10) to
remove the cable clamp.
3. Disconnect two connectors J1 and
J2 from the circuit board.
4. Attach the control cable to the
control unit cover with the cable
clamp (removed at step 2), two
flat head screws (M4), flat
washers, spring washers and nuts
(hardware: supplied).
5. Re-connect two connectors
disconnected at step 3.
6. Fasten eight screws to attach the
control unit cover.
7. Attach the connector seal (supplied) to the hole at the rear of the control unit.
8. Drill a hole of 30 mm in diameter to pass the cable from the bottom of the control unit
through the tabletop
9. Attach the connector seal (supplied) to the hole at the bottom of the control unit when the
above modification is not done.
10. Fix the control unit referring to (2) or (3) on the previous page.
Without KB fixing plate
1-12
Clamp
Fasten the cable with the clamp here.
Control unit, cover removed
Hole for leading in cable
8 4
F S V -
Cable
With KB fixing plate
Control unit, side view
Screw
M4x8 (8 pcs.)
J1
J2
Previous cable hole
Nut
Spring washer
Flat washer
Screw (M4x12)
Cable
Hide quick links:
Advertisement
Table of Contents
