Initial Set-Up; Charging The Battery - Medion Navigation Unit Operating Instructions Manual

Initial Set-up

The following guides you step by step through the initial Set-up of the navigation system.
Firstly, remove the foil from the display.
I. Charging the Battery
You have the following possibilities to charge the battery of your navigation system:
•
by means of the car adapter,
•
by means of the USB cable (optional) or
•
by means of the AC adapter (optional).
Attention!
It can be necessary to recharge the battery for some time initially before it
is possible to run through the initial installation, according to the state of
charging of the battery installed.
Please pay attention to the following notes when handling the battery:
•
The charging status display flashes red until the navigation system is
charged. If possible, do not interrupt the charging process before the
battery is fully charged. This may take a few hours. It will shine green when
the accumulator is completely charged in the case of model nos. E4125 and
P4225. The LED will fade after the end of the charging process in the case of
model P4425.
•
You can use the navigation system during the charging process, but the power
supply must not be interrupted during initial set-up.
•
Leave the external power supply connected to the navigation system for around
24 hours, so that the backup battery also charges-up fully.
•
You can leave the external power supply connected, and this is very handy for
continuous operation. However, the mains adapter (optional) also requires power
even when it is not charging up the battery of the navigation system.
•
It can take several minutes until the device is ready to operate again, following the
connection of the external power supply, if the charging state of the battery is
very low.
•
The battery can be charged while the device is switched off completely.
16 English