Appendix; Special Cleanup Function - Medion Navigation Unit Operating Instructions Manual

Hide thumbs Also See for Navigation Unit:

Table of Contents

Appendix

The CleanUp function serves the targeted deletion of data, without using a PC.

Note

Please use this function very carefully, because it is possible for data to be

deleted that can only be entered again manually afterwards.

The CleanUp function is activated when the 'o' is pressed in the Gopal lettering of the

Main Menu, immediately after the start tone following a reset.

The CleanUp function offers 8 options:

1. Remove Installation Only

Removes the software installed from the 'My Flash Disk'

memory [= part of the permanent memory in which the executable parts of the navigation

software will be located following the initial alignment (\My Flash Disk\Navigation)].

2. Remove MAP Only

Removes the digital maps from the 'My Flash Disk' memory (\My Flash

Disk\MapRegions).

3. Remove Preload Only

Removes the data needed for the installation of the navigation software from the perma-

nent memory (\My Flash Disk\Install).

4. Remove All

Deletes the whole contents of the 'My Flash Disk' memory. It will not be necessary to

recalibrate the screen after this function has been carried out.

5. Factoryreset

Sets the device back to the delivery status in the case of an intact main installation.

Appendix

Table of Contents

Mp3 player