Initial Set-Up; Charging The Battery - Medion Navigation Unit Manual

I S
I S
N I T I A L E
N I T I A L E
The following guides you step by step through the initial set up of
the navigation system.
Firstly, remove the foil for protecting the device during transpor-
tation from the display.
I. C
HARGING THE BATTERY
!
Attention: It can be necessary to recharge the bat-
tery for some time initially before it is possible to run
through the initial installation, according to the state
of charging of the battery installed.
You have different possibilities to charge the battery of your navi-
gation system:
• By means of the car adapter
• With the help of the AC adapter
Please pay attention to the following notes when handling the
battery:
• The charging status display lights orange until the naviga-
tion system is charged. Do not interrupt the charging
process before the battery is fully charged. This may take a
few hours.
The navigation system is fully charged if the charging display
lights green.
• Note: You can use the navigation system during the charg-
ing process, but the power supply must not be interrupted
during initial set-up.
• Leave the mains adapter connected to the navigation sys-
tem for around 24 hours, so that the backup battery also
charges-up fully.
• You can leave the main adapter connected, and this is very
handy for continuous operation. However, the mains
adapter also requires power even when it is not charging
up the battery of the navigation system.
• The battery will also be charging if the main switch is at
the OFF position.
16
-
-
T U P
T U P
E
NGLISH