Initial Set Up; Charging The Battery - Medion E4245 Operating Instructions Manual

Initial Set up

The following is a step by step guide to assist in the initial Set-up of the navigation system.
Start by removing the protective plastic sheet from the display.
I. Charging the Battery
The battery of your navigation system can be charged in the following ways:
•
Using the supplied car adapter,
•
using a suitable USB cable or
•
by using a mains adapter (purchased as an optional extra).
Attention!
It may be necessary to initially charge the battery for a considerable period
of time prior to commencing and running through the initial installation,
this is dependent on the level of charge held at the time by the internal
battery.
Please observe the following notes:
•
The charging status display LED will flash orange until the navigation system is
charged. If possible, do not interrupt the charging process until the
battery is fully charged. This may take a few hours. The charging status LED will
shine constant green if the battery has a high level of charge. Leave the device
charging for 20 further minutes, to ensure the battery is charged-up fully.
•
The navigation system can be used during the charging process, but the power
supply must not be interrupted during initial set-up.
•
Leave the external power supply connected to the navigation system for around
24 hours, so that the backup battery also charges-up fully.
•
The external power supply can remain connected; this is recommended for con-
tinuous operation.
•
Even after a power source has been connected to the device it may take several
minutes until the device is once again ready to operate again, this occurs if the
charging state of the battery is exceptionally low. The battery will continue to be
charged if the power supply is connected and the device is switched off.
12 Initial Set up