Initial Set-Up; Charging The Battery - Medion Navigation Unit Operating Instructions Manual

Initial Set-up

The following guides you step by step through the initial Set-up of the navigation
system.
Firstly, remove the foil from the display.
I. Charging the Battery
Attention!
It can be necessary to recharge the battery for some time initially be-
fore it is possible to run through the initial installation, according to
the state of charging of the battery installed.
Please pay attention to the following notes when handling the battery:
•
The charging status display flashes orange until the navigation system is
charged. If possible, do not interrupt the charging process before the
battery is fully charged. This may take a few hours. The navigation system
is fully charged if the charging display lights green.
The LED will fade after the end of the charging process in the case of Mod-
els 3315 and 3415.
•
You can use the navigation system during the charging process, but the
power supply must not be interrupted during initial set-up.
•
Leave the external power supply connected to the navigation system for
around 24 hours, so that the backup battery also charges-up fully.
•
You can leave the external power supply connected, and this is very handy
for continuous operation. However, the mains adapter (optional) also re-
quires power even when it is not charging up the battery of the navigation
system.
•
It can take several minutes until the device is ready to operate again, fol-
lowing the connection of the external power supply, if the charging state
of the battery is very low.
•
The battery can be charged while the device is switched off completely.
14
English