Iv. Installing The Navigation Software - Medion Navigation Unit Operating Instructions Manual

Note
Brief pressure on the on/off button will be enough to switch the
device on or off, provided that your navigation system is connected
to an external source of electricity or is running in battery operation
(standby mode).
You can adjust the period of operation to suit your needs using the
Settings button on the main screen of your device. Your device is
delivered in a status in which it will not switch off independently.
To switch your navigation system completely off, push the on/off
button at the bottom of the device to the OFF position.
No data will be lost during this because of the storage of data in the
internal memory. The starting process will only last slightly longer.
Your navigation system will use a low amount of electricity and the batteries will be
discharged, even when it is in the standby mode.

IV. Installing the Navigation Software

The final installation of the navigation software will take place automatically from
the internal memory, during the initial setting up, if your device has already been
equipped with the basic data of the navigation software at the factory. Follow the
instructions on the screen.
An optional memory card must always have to be inserted in the device while the
navigation system is being used.
It will be necessary to carry out a Reset to restart the navigation system if the mem-
ory card has been removed (see page 22).
Please also read the chapter Navigation starting on page 23.
18
English