Iv. Installing The Navigation Software - Medion Navigation Unit Operating Instructions Manual

Note
Brief pressure on the on/off button will be enough to switch the de-
vice on or off, provided that your navigation system is connected to an
external source of electricity or is running in battery operation (standby
mode).
You can adjust the period of operation to suit your needs using the
Settings button on the main screen of your device. Your device is deliv-
ered in a status in which it will not switch off independently.
To switch your navigation system completely off, push the on/off button
at the bottom of the device to the OFF position.
No data will be lost during this because of the storage of data in the inter-
nal memory. The starting process will only last slightly longer.
Your navigation system will use a low amount of electricity and the batteries will be dis-
charged, even when it is in the standby mode.

IV. Installing the Navigation Software

The final installation of the navigation software will take place automatically from the in-
ternal memory, during the initial setting up, if your device has already been equipped with
the basic data of the navigation software at the factory. Follow the instructions on the
screen.
An optional memory card must always have to be inserted in the device while the naviga-
tion system is being used.
It will be necessary to carry out a Reset to restart the navigation system if the memory card
has been removed (see page 22).
Please also read the chapter Navigation starting on page 24.
UK/ N. IRELAND HELPLINE 0871 37 61 020
REP. IRELAND HELPLINE 1-800-992508
- 14 -