Disa Security Code Entry/Change/Cancel - Toshiba Strata DK8 User Manual

Digital telephone

Hide thumbs Also See for Strata DK8:

Installation and maintenance manual (609 pages)

Installation instructions manual (584 pages)

User manual (48 pages)

Table Of Contents

Table of Contents

STRATA DK DIGITAL TELEPHONE

To Make an Outgoing Call with

DISA:

1. From outside the system, call

the DISA CO line telephone

number:____-____________.

2. Listen for the ringback tone

signal, then listen for intercom

dial tone.

3. Dial a CO line or line group

access code.

4. If a DISA security code is

required, dial the code, then

listen for CO dial tone.

. . . or . . .

If a DISA security code is not

required, you should hear CO

dial tone.

5. Dial a telephone number.

To Enter, Change, or Cancel the

Code from a Selected Station:

1. Press the Intercom button,

then dial the three-digit

access code.

2-42

See the system administrator for this number.

Try again if you hear busy tone.

Dial tone will be present for 10 seconds to allow direct dialing of a

station intercom number or CO line access code. If a number is not

dialed, the system automatically causes the DISA CO line to ring at

telephones as a normal incoming call. Then, if the call is not answered

within 15 seconds after the ringing starts, it will disconnect.

CO line number access codes are 7 0 1 ~ 7 0 4 (for DK8) and 7 0 1 ~

7 0 8 (for DK16), and line group access codes are 8 1 ~ 8 4 (for DK8)

and 8 1 ~ 8 8 (for DK16). The Least Cost Routing code (9) is not allowed.

If required, see the system administrator for this number. If the correct

code is not entered, the call will be disconnected.

A timer tone that is audible to both parties will sound approximately four

minutes after the call was made. Dial 0 to reset the timer each time the

tone sounds for an additional four minutes. If you fail to dial 0, the call will

disconnect approximately one minute after the tone.