STRATA DK DIGITAL TELEPHONE
To Receive a Handsfree
Intercom Call:
1. You will hear a single long
tone, followed by the caller's
voice.
2. Don't lift the handset; speak
toward the telephone in a
normal voice level.
To Change the Volume while on
the Call:
1. Press the up or down Vol
button until the desired level
is set.
To Turn Off the Microphone:
1. Press the Microphn Cut-
off button.
HANDSFREE ANSWERBACK
You can answer intercom calls without lifting the handset.
The Intercom LED will flash green at the incoming call rate. The Mic LED
will light steady red, indicating your microphone is active. The Spkr LED
will flash red.
If you have a speakerphone, you will have better performance if you
press the Intercom button.
NOTE: The Intercom button must be pressed (or the handset must be
taken off-hook) before placing an intercom call on hold.
HANDSFREE ANSWERBACK VOLUME CONTROL
You can control the volume of the Handsfree Answerback caller's voice.
You can also control this volume while in the idle state. To do so, press
the up or down Vol button and hear ring tone. Continue pressing the
button until the desired volume is set. Adjusting this volume will also
change ring tone volume.
MICROPHONE CUT-OFF
Microphone Cut-off prevents callers from monitoring the sounds near
your telephone. Your station must be assigned with the Microphn Cut-off
button in system programming to activate this feature.
After you press the button, the Microphn Cut-off LED will light steady red,
and the Mic and Spkr LEDs will not turn on when your telephone is being
called.
FEATURE OPERATION
2-17