User Programmable Feature Buttons - Toshiba Strata DK8 User Manual

STRATA DK DIGITAL TELEPHONE
To Use Automatic Hold:
1. While on a call, press another
Line button or the
Intercom button to receive
or originate a new call.
To Switch between Calls:
1. Press the Line or Intercom
button of the held call.
To Store on a Button:
1. Do not lift the handset.
2. Press the Redial button.
3. Press one of the SD buttons.
4. Enter a feature access code
or sequence of codes.
5. Press the Redial button.
After you press the button, the original Line LED will flash at the on-hold
rate, and the original call will be placed on hold.
The LED of the new call will flash at the in-use rate, and the new line will
be accessed.
The LED of the line just automatically placed on-hold will flash at the on-
hold rate, and the LED of the line just accessed will flash at the in-use
rate.

USER PROGRAMMABLE FEATURE BUTTONS

You can program Speed Dial buttons or codes to access features, as
well as telephone numbers. You can store up to 20 digits, enabling you to
access a sequence of features, such as Call Park and Page, with a code
in a Speed Dial button. A list of feature access codes in Table 2-A follows
the storage instructions for this feature.
If you lifted the handset in Step 1, the system would automatically dial
the number that you most recently dialed.
Refer to the Feature Access Code List in Table 2-A.
You can only enter 20 digits maximum. Dialpad digits count as 1 digit,
while the Cnf/Trn, Intercom, and Hold feature buttons each count as two.
The feature access code or codes should be stored in memory.
NOTE: If the preceding sequence is not completed within one or three
minutes (system programmable time), the operation will time out and
your telephone will be placed in the idle condition.
FEATURE OPERATION
2-53