Direct Inward System Access (Disa) Security Code - Toshiba Strata DK System Administration Manual

Direct Inward System Access (DISA) Security
Code
The Direct Inward System Access feature is used when calling into your system from
the outside. This feature is available on certain CO lines and from the built-in Auto
Attendant. Assignments are made by the system programmer. CO lines can be DISA
lines in the Day, Day 2, or Night mode, or any combination of these modes.
If a caller enters the system via a DISA line or built-in Auto Attendant, the caller can
then access another line to place an outgoing call through the system, in which case
the outgoing line call is charged as a call made from the DK system. To prevent
unauthorized outgoing calls through the system using the DISA feature, enter a DISA
security code as shown in the following steps.
CAUTION!
To enter or change the DISA security code
1. Press [DN] +
2. Dial the new DISA
security code (1~15
digits).
3. Press
4. Press
Strata DK System Administrator Guide 5/00
Whenever the built-in Auto Attendant is installed, the DISA
security code should be used (and changed periodically) to prevent
unauthorized access of outgoing CO lines via the Auto Attendant
DISA access feature.
. You hear a confirmation tone.
The DISA security code digit
length is a system program
option. The code appears on
the LCD as you enter it.
. You hear a confirmation tone.
. The telephone returns to the idle mode.
Setting System Parameters

Direct Inward System Access (DISA) Security Code

NO. NNN
____ ID CODE SET
NO. NNN
DATA PROGRAMMED
5