STRATA DK DIGITAL TELEPHONE
To Adjust Muted Tone Burst:
1. Press the Intercom button
and dial 6 1 0 1.
2. Press and hold down the Vol
button.
3. Release the button when the
desired volume is set.
To Set for High-noise
Sensitivity:
1. While holding down the Mic
button, press the up Vol
button for three seconds.
1-10
After you dial 6 1 0 1, you will hear the muted tone for 15 seconds or until
disconnected by pressing the Spkr button.
Press the down arrow volume button to decrease the volume, or press
the up arrow button to increase the volume.
MICROPHONE SENSITIVITY CONTROL
You can set the sensitivity of the microphone on 2000-series
speakerphone models to adjust for the level of room noise.
HIGH-NOISE SENSITIVITY
If it is noisy around your station and people are cutting off while talking to
you on your speakerphone, set your microphone for high-noise
sensitivity.
The Mic LED should flash about six times while setting the sensitivity.
Confirm that the LED flash conforms to the desired mode of operation
(Note 2).
NOTES:
1. This procedure can be performed while idle or on a speakerphone
call.
2. When the microphone is set for high-noise sensitivity, the Mic LED
will flash at the in-use rate when the telephone is busy on a
speakerphone call.
NORMAL SENSITIVITY
The microphone should be set for normal sensitivity operation when the
station is located in a normal office (low-noise level) environment.
GENERAL INFORMATION