Using Redial; Switching From Base Unit (Speakerphone) To The Handset; Switching From Handset To The Base Unit (Speakerphone); Using The Intercom - VTech VT 9171 Manual

The VT9171 cordless phone automatically stores the last number you dialed in a
special redial memory.
To dial the number again,
SWITCHING FROM BASE UNIT (SPEAKERPHONE) TO
THE HANDSET
If you are on a call using base unit (speakerphone) and the handset is in the base,
you can automatically switch from the speakerphone to the handset by picking up
the handset.
SWITCHING FROM HANDSET TO THE BASE UNIT
(SPEAKPHONE)
To switch back to the base unit (speakerphone), you must first press HOLD key on
the handset, then press SPEAKERPHONE key on the base.
NOTE:
YOU cannot switch back to the speakerphone just by returning the handset to the
base that will disconnect the call.

USING REDIAL

1. Press PHONE
2. Press REDIAL provided that you haven't
dialed another number in the meantime.
This feature is also available on the hand-
set and is operated the same way.
JOINING A CONVERSA-
TION
From the Base (Speakerphone)
If someone is speaking on the handset, join
the conversation on the speakerphone by
pressing SPEAKERPHONE on the base unit.
20
From the Handset
If someone is using the speakerphone, join
the conversation by pressing PHONE on the
handset, then leave by pressing OFF key.
Leave the conversation by pressing OFF (on the handset) or SPEAKERPHONE
(on the base unit).
To disconnect the call, both the handset and the base unit must hang up.

USING THE INTERCOM

You can use your VT9171 cordless telephone as a two-way intercom between the
base unit and the handset. This does not tie up your telephone line. You can still
receive calls when using the intercom.
The intercom function can be activated either by the handset or by the base unit.
To call the base unit from the handset,
1.
2.
3.
To call the handset from the base
1.
Press INTCOM on Handset. The
INTCOM indicator will blink and a tone
will sound.
The base will ring once and then auto-
matically enter intercom mode.
Speak towards the microphone.
Press INTCOM on the Base. The
INT.COM indicator will blink and a tone
will sound.
21