Recording/ Playing/ Delete The Ogm's; Time And Day Setup - VTech VT 9171 Manual

Example for ANNOUNCEMENT ONLY OGM:
Hi. You've reached Jack and Jill. We will be back after 1 p.m. Please call us
back then. Thank you.
Note: The ITAD will be automatically turned to Announce-Only OGM if "An-
nounce only" is set.
Recording / Playing / Delete the OGM's
1. Press MENU key until the desired item
("Set Out-Going Message") is an-
nounced.
2. Press MEMO / RECORD and the voice
prompt "Now recording" is an-
nounced. Speak into the microphone
on the base. You can record an OGM
up to 90s in length.
Press MAILBOX X to stop the record-
3.
ing.
4. After finishing the recording, the OGM
replays automatically and let you
check it.
5. To review a recorded announcement,
press MAILBOX X key after the Set
Out-Going Message item selected
(same as paragraph 1).
6. To delete a recorded announcement,
press ERASE key after the Set Out-
Going Message item selected (same
as paragraph 1)
34
NOTE:
- The user MUST set the ANNOUNCE-ONLY setting first before checking or
recording the OGM's. Reversing the procedure will select the OGM wrongly.
- If your recording time is less than 2 seconds, the OGM's will turn to the
default ones.
Security Code Programming
The security code programmed into the ITAD is used to gain access to the func-
tions from remote locations.
The security code default setting is 19.
To change security code:

Time and Day Setup

The Time and Day default is set to Mon 12:00 am. The 7-Segment LED will show
"CL" flashing to indicate clock has not been set or power failure and need to reset
the day and time.
1. Press MENU until you hear "Set Security
Code".
2. Press SET now will announce the current
security code.
3. Press SELECT to increase the security
code by 1 or hold SELECT key for 1 second
to increase the code by
10. The previous setting of security code
will be announced at your first time press-
ing the key.
4. Press SET to confirm your choice and you
will hear the announcement of the current
security code setting.
35