Base Layout - VTech VT 9171 Manual

17
16
15
2
5
9
10
20
21
1. REDIAL key
2. HOLD key
3. MUTE key
4. FLASH key
5. MEM key
6. SPEAKERPHONE key
7. INTERCOM key
8. UP/DOWN keys
9. Dialing keys
10. TONE/* key
11. ANSWER ON/OFF key
10

Base Layout

14
12
13
11
18
19
3
1
4
8
6
7
12. MENU key
13. SELECT key
14. TIME/SET key
15. REC/MEMO key
16. ERASE key
17. REPEAT/SLOW key
18. SKIP/QUICK key
19. Mailbox 1/2/3 keys
20. TONE/PULSE switch
21. RINGER Switch
INSTALLATION of THE HANDSET BATTERIES
IMPORTANT: 1. Don't put the old battery pack in a trash compactor or a fire - it
could burst.
2. Do not dispose of this battery in household garbage. For infor-
mation on recycling or proper disposal, consult your local solid
waste collection or disposal organization.
CAUTION: To reduce the Risk of Fire or Injury to Persons, Read and Follow these
Instructions:
NOTE:
1. Use only VTECH battery.
2. Do not open or mutilate the battery. Released electrolyte is corrosive and
may cause damage to the eyes or skin. It may be toxic if swallowed.
3. Exercise care in handling batteries in order not to short the battery with
conducting materials such as rings, bracelets, and keys. The battery or
conductor may overheat and cause burns.
4. Do not dispose of the battery in a fire. The cell may explode.
IF THE BATTERY PACK DOESN'T RECHARGE
The battery pack can be recharged many times; but if you get a low-battery signal,
or the handset seems completely dead, even after 24 hours of charging, the
battery pack should be replaced. To purchase replacement battery packs, use the
enclosed order for, or call VTECH Communications at 1-800-595-9511.
11
1. Remove the battery case by
pressing on the ridged lines and
sliding downward.
2. Place the battery pack in the bat-
tery compartment. Make sure the
metal contacts on the underside
of the battery are aligned with
charging contacts in battery com-
partment.
3. The battery pack must be
charged before using your tele-
phone. Place the handset in the
cradle of the base unit to allow it
to charge for 16 hours.