Table of Contents
Advertisement
19
Getting started
To use your Bluetooth headset, follow these simple
steps:
•
Charge your headset battery.
•
Turn your headset on.
•
Pair your headset with your Sendo X phone.
•
Wear your headset
!
To charge the battery
Note:
The battery pack for your Bluetooth
headset is already installed when you purchase
your headset. If the battery pack has been
removed, or for instructions on re-installing the
battery, see
on Page
157.
1. Connect the Sendo X phone charger to the
mains power supply and then to the headset
charger connector.
2. Within a few seconds, the indicator light will
illuminate red. The indicator light will turn green
when the headset is fully charged.
Charge the headset overnight or for at least 8 hours
before first use. Subsequent charges take
approximately 90 minutes.
When the headset is on and the battery becomes
low, the headset emits a beep every 20 seconds. The
indicator light also flashes red when the battery
needs to be recharged. Recharge the battery as
described above.
Replacing or installing a new battery
Tip:
Fully draining the battery once a month can
improve battery life. Otherwise, it is best to
charge your headset whenever possible. Avoid
charging in excessive heat (above 104ºF/40ºC)
or cold (below 50ºF/10ºC).
The headset can also be charged using the Sendo X
phone in-car charger (supplied separately).
!
To turn your headset on/off
1. Unplug your headset from the charger and then
press and hold the power/mute button until the
indicator light flashes green.
2. The indicator light will flash green every 2-3
seconds whilst the headset is on.
3. To turn your headset off, press and hold the
power/mute button until the indicator light turns
red.
!
To pair your headset
1. Before using your headset for the first time, you
must pair it with your Sendo X phone. First, make
sure your phone and headset are both on.
2. Place the headset and phone where they are
easily viewable.
3. In the
Menu
screen of your phone, use the
joypad to scroll to the
press
Select
.
4. Scroll to
Bluetooth
5. A list of Bluetooth settings is displayed. Highlight
the
Bluetooth
setting, and use the
to switch the setting to On.
153
Connectivity
icon, and
and press
Select
.
Select
Sendo X User Guide
key
Advertisement
Table of Contents
