Connecting The Cuff To The Monitor; Applying The Cuff - HMM smartLAB profi User Manual

Connecting the cuff to the monitor

Insert the cuff tubing connector into the
socket of your smartLAB
side of the monitor (see pict. 5). Make sure
that the connector is completely inserted
to avoid air leakage during blood pressure
measurements.

Applying the cuff

• Place the cuff around a bare arm 1-2cm above the elbow joint
(see. pict. 6)
• While seated, place palm upside in front of you on a flat surface
such as a desk or table. Position the air tube in the middle of your
arm in line with your middle finger.
• Pull the cuff end through the metal loop (the cuff is packaged
like this already), turn it outward (away from your body) and
tighten it and close the Velcro fastener.
• The cuff should fit comfortably, yet snugly around your arm. Y o u
should be able to insert one finger between your arm and
cuff.
Abb. 3h
profi+ on the left
®
Abb. 3i
pict. 5
pict. 6
t h e
19