Specifications - Classe Audio CAP-2100 Owner's Manual

Specifications
Classé Audio reserves the right to make improvements without notice.
■ Power output (both channels driven)
■ Frequency response
■ Phase
■ Signal-to-noise ratio
■ Channel separation
■ Noise floor (FFT)
■ Distortion (THD + noise)
■ Maximum input voltage
■ Voltage gain range
■ Sensitivity (SSP input)
■ Input Impedance
■ Output Impedance (main output)
■ Input complement
■ Output complement
■ Crosstalk (any input to any output)
■ Rated power consumption (as per IEC60065 - para.2.3.10)
■ Idle power consumption
■ Mains voltage
■ Dimensions (not incl. controls or connectors)
■ Shipping weight
■ Net weight
For more information, see your Classé dealer or contact:
Classé Audio
5070 François Cusson
Lachine, Quebec
Canada H8T 1B3
Telephone +1 (514) 636-6384
FAX +1 (514) 636-1428
http://www.classeaudio.com
email: cservice@classeaudio.com
Classé and the Classé logo are trademarks of Classé Audio Inc. of Lachine, Canada. All rights reserved.
i-Command is a trademark of Equity International, Inc. All rights reserved.
™
AMX is a registered trademark of AMX Corporation of Richardson, TX. All rights reserved.
®
Crestron is a trademark of Crestron Electronics, Inc. of Rockleigh, NJ. All rights reserved.
™
100W/ch continuous rms @ 8Ω
200W/ch continuous rms @ 4Ω
10Hz – 22kHz (+0/-0.1dB)
10Hz – 155kHz (+0/-3.0dB)
better than 95dB @ 20kHz
(unweighted, 0.8Vrms/1kHz input, 10Hz – 80kHz)
0.5Vrms for rated output (single-ended)
1.0Vrms for rated output (balanced)
1 balanced (XLR), 4 single-ended (RCA)
specified on rear panel decal
(cannot be changed by user or dealer)
less than -10° @ 22kHz
95dB typical
all peaks less than -90dBV
(10Hz – 80kHz)
0.005% @ 8Ω
3.8Vrms (single-ended)
7.8Vrms (balanced)
-100dB to +14dB
100kΩ
100Ω
2 single-ended (RCA)
better than -95dB
260W
125W
Width: 17.5" (445mm)
Height: 4.75" (121mm)
Depth: 16.5" (419mm)
59lbs (27kg)
50lbs (23kg)
37