Classe Audio CAP-2100 Owner's Manual page 33

3. Only one speaker seems to be playing.
• Check the main balance control setting of the CAP-2100 by
• Does the problem occur with all inputs? If so, check the
Important! Be certain that the integrated amplifier is off before checking
any connections between the speakers and the integrated
amplifier.
• If the problem occurs only with a particular input, check the
• If the input balance appears to be correct, check the interconnect
4. The IR remote control seems not to function.
• Ensure that there are no obstacles between the IR remote and the
• If the batteries are weak, replace them with fresh ones.
• Make sure there are no keys stuck on your Classé remote or on
5. There is a hum coming out of the speakers.
• Make sure your single-ended interconnects are not running
• If any source components connected to your integrated amplifier
• If you have the optional phono module in your integrated
• If the hum exists only on the phono input, make sure
• Make sure the tonearm cable is not touching or running
• Make sure you have the proper loading for your phono cartridge.
pressing the Menu button, followed by the Balance button.
interconnect cables between the source component and the CAP-
2100 input. If no fault is found there, check the speaker wires for
secure connections.
input balance control setting of that particular input:
Menu • system setup • input • input name • balance
where input name is the particular input in question.
cables between the corresponding source component and the
CAP-2100.
IR sensor (located to the right of the Mute button).
any other remote control in the room.
alongside any AC power cords. (Long runs of single-ended
interconnects have a natural tendency to pick up noise even if
they are shielded.)
has a cable TV hooked up to it, try disconnecting the cable
television line from the source. If the hum goes away, you will
need an isolation device between your cable and that particular
source. Refer to your Classé dealer for one of these inexpensive
devices.
amplifier, make sure that the ground wire of the tonearm is
secured properly to the ground lug on the back of your preamp.
the turntable/tonearm assembly is not too close to other
components. There should be at least 12 inches (30cm) clearance
from the other components. The more clearance you provide, the
better (as long as the tonearm cable is not stretching).
alongside an AC cable.
If you are in doubt, consult your authorized Classé dealer.
33