Table 5-1: Signaling Protocol Tab Parameters Description - AudioCodes MP-20x User Manual

MP-20x Telephone Adapter

Table 5-1: Signaling Protocol Tab Parameters Description

Parameter
Signaling Protocol
Signaling Protocol
SIP Transport Protocol
Local SIP Port
Gateway Name-User Domain This domain name is sent in the From header of outgoing Invite
Enable PRACK
Include ptime in SDP
Enable rport
Connect media on 180
Enable Keep Alive
Keep Alive Type
Keep-Alive Period
SIP Proxy and Registrar
Use SIP Proxy
Host Name or Address
Version 3.0.1
Signaling protocol running on the device. In the current version
release, only SIP (Session Initiation Protocol) is supported.
Choose either UDP (default) or TCP.
Note: This parameter appears only in 'Advanced' mode.
The UDP/TCP port (default = 5060) on which the Stack listens.
Note: This parameter appears only in 'Advanced' mode.
messages.
Note: This parameter appears only in 'Advanced' mode.
When enabled, MP-20x replies with a PRACK message upon receipt
of a reliable provisional response. MP-20x does not initiate reliable
provisional responses.
Note: This parameter appears only in 'Advanced' mode.
When enabled, MP-20x adds the ptime field to the SDP message
body.
Note: This parameter appears only in 'Advanced' mode.
When enabled, MP-20x adds the rport parameter to the relevant SIP
Message fields.
Note: This parameter appears only in 'Advanced' mode.
When enabled, media is connected upon receipt of SIP 180, 183, or
200 messages. When the parameter is disabled, media is connected
upon receipt of 183 and 200 messages only.
Note: This parameter appears only in 'Advanced' mode.
When enabled, a keep-alive notification is sent every user-defined
interval to the SIP registrar entity.
Note: This parameter appears only in 'Advanced' mode.
The type of keep-alive mechanism sent to the SIP registrar entity:
Using SIP OPTIONS: sends a SIP OPTIONS message
•
Using an Empty UDP packet: sends an empty UDP packet
•
Note: This parameter appears only if "Enable Keep Alive" is selected.
Sets the periodic interval.
Note: This parameter appears only if "Enable Keep Alive" is selected.
When checked, outgoing calls are routed to the configured SIP proxy.
If the parameter 'Use SIP Proxy IP and Port for Registration' is
checked as well, the configured SIP proxy is also used as the
registrar, allowing incoming calls.
The IP address or host name of the SIP proxy.
39
5. Configuring VoIP Parameters
Description
July 2010