5.1.1
Configuring Signaling Protocol Parameters
Note:
To configure signaling protocol parameters:
After clicking the menu 'Voice over IP' in the main screen, the 'Signaling Protocol'
screen opens by default (refer to the figure below).
Parameter
Use SIP Proxy
Use SIP Registrar
Use SIP Outbound
Proxy
Check the checkbox 'Use SIP Proxy'; the 'SIP Proxy' screen (showing basic
parameters) opens. Click the button 'Advanced>>'; the 'SIP Proxy' screen (showing
MP-202 Telephone Adapter
In the current version release, only SIP (Session Initiation Protocol) is
supported.
Figure 5-1: VoIP - Signaling Protocol
Table 5-1: VoIP - Signaling Protocol
When checked, outgoing calls will be routed to the configured SIP proxy. If
the parameter 'Use SIP Proxy IP and Port for Registration' is checked as
well, the configured SIP proxy will also be used as the registrar, allowing
incoming calls.
Check to use a separate SIP registrar server. Default is unchecked.
Use an outbound SIP proxy (all SIP messages will be sent to this server as
the first hop). Default is unchecked.
Description
36
MP-202
LTRT-50604