Applicable Standards And Reference Documentation; Standards - Seagate ST11200N Product Manual

2
______________________________________________________________________________________
2.0

Applicable standards and reference documentation

The drive has been developed as a system peripheral to the highest standards of design and construction.
The drive depends upon its host equipment to provide adequate power and environment in order to achieve
optimum performance and compliance with applicable industry and governmental regulations. Special at-
tention must be given in the areas of safety, power distribution, shielding, audible noise control, and tem-
perature regulation.
2.1

Standards

The Hawk 1 Family complies with Seagate standards as noted in the appropriate sections of this specifica-
tion and the Seagate SCSI-2 Interface Specification, P/N 77738479 (Vol. 2, Version 2).
The Hawk 1 Family is a UL Recognized component per UL 1950 and a CSA Certified component per CAN/
CSA-C22.2 No. 950-M89. It also meets the requirements of DIN VDE 0805/05.90 and EN60950: 1988 (IEC
950).
The Hawk 1 family drives, as delivered, are designed for system integration and installation into a suitable
enclosure prior to use. As such the Hawk 1 family drives are supplied as a sub-assembly and is not subject
to Subpart J of Part 15 of the FCC Rules and Regulations nor the Radio Interference Regulations of the
Canadian Department of Communications. However, the unit has been tested using proper shielding and
grounding and found to be compliant with Class A limits of the FCC Rules and the Regulations of The
Canadian Department of Communications.
The physical design characteristics of the Hawk 1 family drives serve to minimize radiation when installed in
an enclosure that provides reasonable shielding. As such, the Hawk 1 family drives are capable of meeting
the Class B limits of the FCC Rules and Regulations of the Canadian Department of Communication. How-
ever, it is the users responsibility to assure that the Hawk 1 family drives meet the appropriate EMI require-
ments in their system. Shielded I/O cables may be required if the enclosure does not provide adequate
shielding. If the I/O cables are external to the enclosure, shielded cables should be used, with the shields
grounded to the enclosure and to the host controller.
Caution. To avoid potential service problems, observe the following precautions:
The Manufacturers installed labels must not be removed from the drive or covered with addi-
tional labels, as they contain information required when servicing the product.
Product Manual - Hawk 1 Family SCSI-2 (Volume 1), Rev. D