Scsi Interface Commands Supported - Seagate ST11200N Product Manual

42
______________________________________________________________________________________
11.3

SCSI interface commands supported

Table 11.3-1 following lists the SCSI interface commands that are supported in the SCSI-1 and SCSI-2
modes of the drive. Hawk 1 Family drives can be changed back and forth between SCSI-1 and SCSI-2
modes using the Change Definition Command. OEM standard drives are shipped set to operate in SCSI-2
mode.
Com'd Supported by:
Code SCSI-1
00h Y
01h Y
03h Y
Y
Y
N
04h Y
07h Y
08h Y
0Ah Y
0Bh Y
12h Y
N
N
N
N
N
N
15h Y
16h Y
Y
N
17h Y
18h N
1Ah Y
Y
Y
Y
Y
Y
Y
Y
N
Y
N
N
[1] Hawk 1 can format to any even number of bytes per sector from 256 to 4096.
Product Manual - Hawk 1 Family SCSI-2 (Volume 1), Rev. D
Table 11.3-1. Commands supported by Hawk 1 family drives
SCSI-2
Y
Y
Y
Y
Y
N
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
N
Y
N
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Y
Command Name
Test unit ready
Rezero unit
Request sense
Extended sense
Field pointer bytes
Actual retry count bytes
Format unit [1]
Reassign blocks
Read
Write
Seek
Inquiry
Vital product data page
Unit serial number page
Implemented operating def. page
Firmware numbers page
Date code page
Jumper settings page
Mode select (same pages as mode
sense command see below)
Reserve
3rd parity reserve
Extent reservation
Release
Copy
Mode sense
Unit attention page (00h)
Byte 2 bit 4 (unit attn bit)
Byte 2 bit 5 (DEID bit
Error recovery page (01h)
Disconnect/reconnect
Control page (02h)
Format page (03h)
Rigid disc drive geometry page (04h)
Verify error recovery page (07h)
Caching parameters page (08h)
Control mode page (0Ah)
Notch and Partition Page (0C) (Media Zones)