Interface Requirement; General Description; Scsi Interface Messages Supported - Seagate ST11200N Product Manual

Product Manual - Hawk 1 Family SCSI-2 (Volume 1), Rev. D
_____________________________________________________________________________________
11.0 Interface requirements
11.1

General description

This section partially describes the interface requirements as implemented on the drives. The major portion
of the interface requirements/implementation is described in the Seagate SCSI Interface Product Manual,
P/N 77738479. This section has tables that give the Hawk 1 Family drives version of the SCSI implementa-
tion described in the 77738479 document.
11.2

SCSI interface messages supported

Table 11.2-1 following lists the messages supported by the SCSI-1 and SCSI-2 modes of the Hawk 1 Family
drives.
Table 11.2-1. SCSI messages supported by ST11200N/ND family drives
Msg Supported by:
Code SCSI-1
01h*** Y
06h Y
0Dh Y
0Ch Y
0Eh N
00h Y
04h Y
80h-FFh Y
23h N
0Fh N
05h Y
0Ah N
0Bh N
09h Y
07h Y
*** N
08h Y
21h N
22h N
20h N
10h N
03h Y
02h Y
*** Y
11h N
*** N
***Extended messages (see P/N 77738479 SCSI Interface Product Manual).
SCSI-2Message Name
Y Extended messages
Y Abort
Y Abort tag
Y Bus device reset
Y Clear queue
Y Command complete
Y Disconnect
Y Identify
N Ignore wide residue (two bytes)
N Initiate recovery
Y Initiator detected error
N Linked command complete
N Linked command complete with flag
Y Message parity error
Y Message reject
Y Modify data pointer
Y No operation
Queue tag messages (two bytes)
Y Head of queue tag
Y Ordered queue tag
Y Simple queue tag
N Release recovery
Y Restore pointers
Y Save data pointer
Y Synchronous data transfer req.
N Terminate I/O process
N Wide data transfer request
41