Connecting The Ac Power Cord - Christie LWU505 User Manual

Installation
This projector uses nominal input voltages of 100–240 V
AC and it automatically selects the correct input voltage.
It is designed to work with single-phase power systems
having a grounded neutral conductor. To reduce the risk of
electrical shock, do not plug into any other type of power
system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service center.
Connect the projector with all peripheral equipment before
turning on the projector.
CAUTION
The AC outlet must be near this equipment and must be
easily accessible.
Note:
NOTE ON THE POWER CORD
AC power cord must meet the requirements of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If the supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
To POWER CORD
CONNECTOR on
your projector.
22

Connecting the AC Power Cord

AC Outlet side
For the U.S.A. and Canada
Ground
To the AC Outlet.
(120 V AC)
Connect the AC power cord (supplied)
to the projector.
For Continental Europe
To the AC Outlet.
(200–240 V AC)
LWU505 User Manual
020-000374-01 Rev.1 (01-2011)