Displaying The Picture - Christie LWU720i Setup Manual

Displaying the picture

1.
Activate your signal source. Turn the signal
source on, and make it send the signal to the
projector.
2.
Use the VOL + / - buttons to adjust the volume.
3.
Press the INPUT button on the projector.
Each time you press the button, the projector
switches its input port in turn.
You can also use the remote control to select
an input signal. Press any of the buttons from
COMPUTER 1, VIDEO, LAN, HDMI 1 / 2,
DisplayPort, HDBaseT, SDI (LWU720i/LHD720i)
to select the input signal from each port.
4.
Press the ASPECT button on the remote control.
Each time you press the button, the projector
switches the mode for aspect ratio in turn.
5.
Use the ZOOM + / - buttons on the remote
control or ZOOM button and ◄/► cursor buttons
on the projector to adjust the screen size.
6.
Use the FOCUS + / - buttons on the projector or
the remote control to focus the picture.
ZOOM button
FOCUS - / + buttons
CAUTION ►If you want a blank screen while the projector's lamp is on,
use the shutter or AV MUTE function. Taking any other action may cause the
damage to the projector.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• There may be some noise and/or the screen may fl icker for a moment when an
operation is made. This is not a malfunction.
• For the details of how to adjust the picture, see User's Manual - Operating
Guide.
LWU720i/LHD720i/LWU620i
Setup Guide
FOCUS + / -
buttons
15
VOL + / -
buttons
INPUT button
Buttons for input ports
ASPECT
button
ZOOM + / -
buttons
020-001337-01 Rev. 1 (10-2017)