P Insert the projection of the band (wireharness) into
the hole of the frame.
Q 1: Speed sensor connector
2: AC magneto connector
3: Sidestand switch connector
4: Oil level switch connector
5: Meter ground lead
R Fasten the leads (above 1 – 5) and starter motor
lead with a steel band on the engine.
S Route the fuel tank breather hose and fuel tank
drain hose over the wireharness.
T Route the starter cable with slot of the heat protec-
tion plate.
CABLE ROUTING
U Route the starter cable and wireharness through
the guide of the heat protection plate.
V Route the fan motor lead under the throttle cable
and then, fasten the fan motor lead and throttle
cable with a band.
W To radiator fan motor
2-39
SPEC