Adjusting The Shift Pedal; Adjusting The Drive Chain Slack - Yamaha YZF-R6 99 Service Manual

ADJUSTING THE SHIFT PEDAL/

ADJUSTING THE DRIVE CHAIN SLACK

3-45
EB304081
ADJUSTING THE SHIFT PEDAL
NOTE:
The shift pedal position is determined by the
installed.
1. Measure:
S incorrect ! Adjust.
The top of sift pedal should be
aligned with the lower part of the
bracket. (from the horizontal view)
2. Adjust:
S installed shift rod length
a. Loosen both locknuts 1 .
b. Turn the shift rod 2 in direction b or c to
obtain the correct shift pedal position.
Installed shift rod length
Direction b
increases.
Installed shift rod length
Direction c
decreases.
c. Tighten both locknuts.
d. Make sure that the installed shift rod length is
within specification.
EB304092
ADJUSTING THE DRIVE CHAIN SLACK
NOTE:
The drive chain slack must be checked at the
tightest point on the chain.
CAUTION:
A drive chain that is too tight will overload
the engine and other vital parts, and one that
is too loose can skip and damage the swin-
garm or cause an accident. Therefore, keep
the drive chain slack within the specified
limits.
1. Stand the motorcycle on a level surface.
WARNING
Securely support the motorcycle so that
there is no danger of it falling over.
NOTE:
Place the motorcycle on a suitable stand so that
the rear wheel is elevated.
CHK
ADJ