Vemer Dafne User Manual page 29

5. Once all parameters are set , to exit and go back to the programming menu, press
for a short time the key
To exit and go back to the normal operation (automatic, manual) press for a long
time the key or wait for the time-out expiration (30 seconds about).
If a timing is active, the display shows the symbol
To interrupt a timing, access again the menu and set the value 00.
With the ADV menu it's possible to modify the
following operation parameters:
- operating mode (heating or cooling)
- regulation type (on-off or proportional)
- parameters relative to regulation type
- antifreeze temperature
- password for keylock
- system operation hours.
To access the menu ADV:
symbol
to access the parameters modification
press the keys
and to move to the next parameter. To exit the parameters modification press
the key .
.
until the symbol
and to modify the parameter and the key
- 27 -
Dafne programmable thermostat, user's manual
.
until the
to confirm