Speaker Connection - Sharp SD-AS10H Operation Manual

Speaker connection

SD-AS10H
ENGLISH
Make sure to leave the AC power lead disconnected when connecting the
speakers.
To prevent accidental short circuits between
speaker wires to the speakers first and then to the unit.
Connect the speaker and the unit by matching the colours.
1
Connect the wires to the speakers.
Example: To connect the right surround speaker.
2
Connect the other end to the amplifier unit.
Tube (grey)
E-17
and terminals, connect the
Label
(grey)
Black Red
Tube (grey)
Speaker terminal (grey)
Red
Black
Amplifier unit
Caution:
" The supplied speakers are designed exclusively for the SD-AS10H. Do not
connect these speakers to other equipment. Also, do not connect other
speakers to the SD-AS10H. It may cause malfunction.
" Do not mistake the
and , and right and left terminals of the speaker wires. (The
right speaker is placed on the right when you face the unit.)
" Do not let the bare speaker wires touch each other.
" Do not stand or sit on the speakers. You may be injured.
" Do not short-circuit the speaker wire. If it happens with the
power on, the protection circuit is activated and the unit is
set to the power stand-by mode. In this case, check that the
speaker wire is connected correctly before turning on the
power again.
" The speakers grilles are not removable.
" Do not allow any objects to fall into or to be placed in the bass
reflex ducts.
Non-slip sheet for speakers:
Attach the sheets to the bottom of the speaker to prevent it from sliding.
Front/surround speakers
Non-slip sheet for speakers
05/3/17 SD-AS10H_SEEG_E.fm
Incorrect
Centre speaker
Non-slip sheet
for speakers
TINSZA116AWZZ